Key points of JIS draft
Key points of JIS draft
The outline of the JIS draft in the following table is at the public opinion acceptance stage. They may be changed or corrected depending on the results of deliberation of JIS drafting & deliberation Committee instituted in the Accredited Standards Developing Organization.
| Standard number | B8403-2 |
|---|---|
| Standard title | Pneumatic fluid power - Mounting dimensions for accessories - Part 2: Rod end clevis， 1MPa series |
| Objective |
This standard specifies the dimensions of female rod clevises in accessory fittings used with 1 MPa series pneumatic cylinders specified in JIS B 8368-1 to JIS B 8368-3. It was revised in 2013 based on ISO 8140 (Pneumatic fluid power -- Cylinders， 1 000 kPa (10 bar) series -- Mounting dimensions of rod-end clevises)， which was revised in 2009. However， JIS B 8368-1 [Mounting dimensions of pneumatic cylinders -- Part 1: Single rod -- 1 MPa series -- Square cover type -- Tie rod tightening (fixed mounting bracket) type (inner diameter 32 mm to 250 mm)]， which is a referenced standard and listed in the scope of application， has been discontinued， and this required an addendum. The corresponding international standard was revised in 2018， and ISO 6430， the corresponding international standard for JIS B 8368-1， was no longer cited at this time. Furthermore， as the other revisions already correspond to the revisions in the corresponding international standards， it is not believed necessary to revise the JIS to match them. Furthermore， as a result of this revision， the scope of application will be consistent with the 2018 editions of the corresponding international standards. The main revisions are as follows: - In terms of the scope of application， ゛JIS B 8368-1 to JIS B 8368-3゛ will be replaced with ゛JIS B 8368-2 and JIS B 8368-3.゛ |
| The number and equivalent nature sign of an international standard which were used as the foundation | MOD ISO 8140:2018 Pneumatic fluid power - Cylinders， 1 000 kPa (10 bar) series - Mounting dimensions of rod-end clevises |
| International classification for standard, ICS | 23.100.20 |
